Configure Korg MS2000(B)(R) for our plug-in

Configuration Knowledge Level

Configuration articles and guides for software and hardware. These settings are mandatory unless otherwise stated

Instructions what to do before inserting our plug-in to project

First we need to make sure the hardware is ready to communicate with the software. In order to do so, we need to make sure that some pre-required settings are set accordingly.

Plug your MIDI cables to the MIDI device and Audio Jacks to your mixer / soundcard.
MIDI out from synth to MIDI device in and vice versa. No MIDI thru or other ports.

Configure Korg MS2000(B) / MS2000(B)R for our plug-in

Fire up your MS2000 or MS2000R and enter Global settings with “GLOBAL” button below the display. Use “CURSOR” and “PAGE” buttons to navigate around the settings.

Configure Korg MS2000 for MS2KxR

Configure Korg MS2000 – Accessing Functions

  • Click “PAGE +/-” buttons to see page “G2A MEMORY” and set Protect to OFF.
  • Click “PAGE +/-” buttons to see page “G3A MIDI” and set MIDI Ch to 1.
  • Click “CURSOR </>” buttons to see “G3B MIDI” and set Local to on or off.
  • Click “CURSOR </>” buttons to see “G3C MIDI” and set Clock to Internal. Arpeggiator will not play unless DAW is unable to provide MIDI Clock. Windows: Check our method of using MIDI OX and LoopBe together to provide MIDI clock from DAW to your synth.
  • Click “PAGE +/-” buttons to see page “G4A MIDI FILTER” and set ProgChg to ENA.
  • Click “CURSOR </>” buttons to see “G4B MIDI FILTER” and set CtrlChg to ENA.
  • Click “CURSOR </>” buttons to see “G4C MIDI FILTER” and set P.Bend to ENA.
  • Click “CURSOR </>” buttons to see “G4D MIDI FILTER” and set SystemEx to ENA.
  • Click “CURSOR </>” buttons to see “G4E MIDI FILTER” and set NoteRcv to ALL.

Exit this view by clicking “EXIT” – Display returns to normal state.

All set! We are now ready to open our plug-in in DAW!

To get more information about how to adjust your synth, read the Korg MS2000 User Manual.

0
0
264
Rate this article

Spread the word with your community ❤️ Thank you!

0 Shares
Tweet
Share
Reddit
Share
Share