Configure Waldorf Pulse 2 for our plug-in

Configuration Knowledge Level

Configuration articles and guides for software and hardware. These settings are mandatory unless otherwise stated

Instructions what to do before inserting our plug-in to project

First we need to make sure the hardware is ready to communicate with the software. In order to do so, we need to make sure that some pre-required settings are set accordingly.

Plug your MIDI cables to the MIDI device and Audio Jacks to your mixer / soundcard.
MIDI out from synth to MIDI device in and vice versa. No MIDI thru or other ports.

If you synth comes with USB connection and there is only one MIDI input or MIDI output port, then we recommend to use USB connection instead.

Configure Waldorf Pulse 2 for our plug-in

Fire up your Pulse 2. Our plug-in is designed to work “out of the box” and control all parameters from single plug-in instance.

After Pulse 2 is powered up, enter Global settings and apply following settings.

Click and hold SHIFT + Global and apply the settings below:

  • MIDI CHANNEL = 1
  • MIDI THRU = OFF
  • TX ARP CLOCK = OFF
  • TX ARP NOTES = OFF
  • TX PARAMETERS = CC+SYS
  • DEVICE ID = 0 (If you have multiple units, make sure they have different ID).

All set! We are now ready to configure our DAW!

To get more information about how to adjust your synth, read the Waldorf Pulse 2 User Manual.

0
0
446
Rate this article

Spread the word with your community ❤️ Thank you!

0 Shares
Tweet
Share
Reddit
Share
Share